TwoSun TS81 D2 Factory edge put to the rope
TwoSun TS81 D2 Factory edge put to the rope
TwoSun TS81 D2 -- Factory Edge does the rope challenge .
Result was a 200 slice fail .
Re sharpened on the whetstone grinder !
Wow , that was a horrendously poor factory edge . It was all over the place ( grind ) .
It took a lot of work to clean up , and that might explain the 200 fail . ( steps of 50 )
Knife has a fresh edge , steel felt hard on the grinder (?) , can only hope !
Next , I will put the fresh edge to the rope and see what happens .
-
- Posts: 107
- Joined: Tue May 04, 2021 10:01 pm
Re: TwoSun TS81 D2 Factory edge put to the rope
Hmmm, I watched your video and that is about the quality I would expect from a Chinese knife.old4570 wrote: ↑Sun May 09, 2021 2:53 am
TwoSun TS81 D2 -- Factory Edge does the rope challenge .
Result was a 200 slice fail .
Re sharpened on the whetstone grinder !
Wow , that was a horrendously poor factory edge . It was all over the place ( grind ) .
It took a lot of work to clean up , and that might explain the 200 fail . ( steps of 50 )
Knife has a fresh edge , steel felt hard on the grinder (?) , can only hope !
Next , I will put the fresh edge to the rope and see what happens .
Re: TwoSun TS81 D2 Factory edge put to the rope
For a factory edge , eeeeh !
It has a fresh edge , and I am just waiting for it not to be so cold N windy . ( Brrrr )
If it's D2 , and it's hard . It should / could perform . Will see .
TwoSun is a little hit and miss ...
It has a fresh edge , and I am just waiting for it not to be so cold N windy . ( Brrrr )
If it's D2 , and it's hard . It should / could perform . Will see .
TwoSun is a little hit and miss ...