Page 1 of 1

Kissing crane piece needed

Posted: Fri Apr 07, 2017 9:34 pm
by GClaxon
Looking for the locking spring for this 4 inch lockback. The one on the end of the knife
image.jpg
image.jpg

Re: Kissing crane piece needed

Posted: Sat Apr 08, 2017 3:35 pm
by muskrat man
These are easily made and installed. I just did one a week or two back. I can supply a piece of spring steel the correct width, you'll just need to bend it and trim it to length. Or you can send me the knife and I'll fix it.

Re: Kissing crane piece needed

Posted: Sat Apr 08, 2017 6:27 pm
by GClaxon
I'll get with ya muskratman

Re: Kissing crane piece needed

Posted: Tue Apr 11, 2017 8:40 pm
by just bob
When you get this knife apart you will find that the tail pc. is actually carbon fiber or some kind of hard rubber. Those 2 pins work together to keep the tension bar in place. Over time the synthetic material develops slop and the tension bar comes out. I had a small pc. of n/s and used the old tail pc as template and got this back together. Doubtful you can reuse the original tail pc. But maybe Kaleb can work his magic.