Had this roll into the shop. 6 inch blade which was made by a blacksmith. He decided he would like a handle on it instead of just steel. So I added a brass bolster and maple handle. Then of course it needed a sheath.
Thought I'd share
Ross
Handle and a sheath
Handle and a sheath
- Attachments
-
-
-
Einhornllc Custom knives and leather.
Come stroll around my AAPK store sit a spell maybe buy a knife or two
https://www.allaboutpocketknives.com/rossr
https://www.einhorncustom.com/
Come stroll around my AAPK store sit a spell maybe buy a knife or two
https://www.allaboutpocketknives.com/rossr
https://www.einhorncustom.com/
Re: Handle and a sheath
Nice leather work! I am not to the point of doing all the nice tooling on the leather that you have done. Someday maybe I will give it a try but I am usually more focused on the knife than the sheath when I'm making something.
Dale
AAPK Administrator
Please visit my AAPK store: www.allaboutpocketknives.com/orvet
Job 13:15
"Buy more ammo!" - Johnnie Fain
“Evil is Powerless If The Good are Unafraid.” – Ronald Reagan
AAPK Administrator
Please visit my AAPK store: www.allaboutpocketknives.com/orvet
Job 13:15
"Buy more ammo!" - Johnnie Fain
“Evil is Powerless If The Good are Unafraid.” – Ronald Reagan
Re: Handle and a sheath
Dale I think that's pretty common of knife makers the sheaths are just secondary. Not a judgement just an observation. As far as stamping work it's not hard to do and you can pick it up easily and do it pretty quick imo.
Best and Thanks
Ross
Einhornllc Custom knives and leather.
Come stroll around my AAPK store sit a spell maybe buy a knife or two
https://www.allaboutpocketknives.com/rossr
https://www.einhorncustom.com/
Come stroll around my AAPK store sit a spell maybe buy a knife or two
https://www.allaboutpocketknives.com/rossr
https://www.einhorncustom.com/