All About Pocket Knives

I'm thinking about making some of these knives.
Just curious of the interest in them?
I have made a couple, and I'm working on the design of one to knock your socks off.
And I appreciate all who take the time to answer the poll.

Here is the last one I made and sold.

Thank you all.

Todd Davison

What would they sell for Todd? Are those micarta scales and what is the blade steel? I like the looks of it.

Forensic Jim wrote:What would they sell for Todd? Are those micarta scales and what is the blade steel? I like the looks of it.

The cost would be $275.00 - $325.00 depending on what I put into the knife?
Such as Shield or no Shield? - Scales Material? - and I working on a NO liner one? don't know yet on that?
The steel would probably be - ATS34 stainless.

The one above is Micarta Scales - Sold for $325.00 shipped and insured in a protective case.
And I do not use any patterns, but if I get the design I want down.
I would be able to make them a little quicker, and get the cost down?
That is why I made this post, just checking on the interest in them as a custom made.

For those that do not know? A Shadow Pattern is a Slip Joint with no Bolsters.
Bolsters are the steel pieces you see on the front of a pocket knife.
If you look at the knife above, it does NOT have them.
It makes for a light weight knife, great for every day carry - EDC.

Any other questions or comments are very welcomed.

Thank you!

Todd Davison