Page 1 of 1
Engraved Spyderco Byrd
Posted: Fri Apr 08, 2011 3:41 am
by cavemans workshop
Here is a knife I just finished engraving. I usually overlay these with silver, making for an easier metal to engrave. This one I didn't do that, I just engraved the stainless steel handle in a Western Bright cut design. Thanks for looking, all comments welcome.
Re: Engraved Spyderco Byrd
Posted: Fri Apr 08, 2011 5:56 am
by zed6309
That looks amazing, im sure i have seen some of your work before while googling,
Re: Engraved Spyderco Byrd
Posted: Fri Apr 08, 2011 8:14 pm
by johnnierotten
Great job!!
Re: Engraved Spyderco Byrd
Posted: Fri Apr 08, 2011 9:51 pm
by philco
That is impressive work. Thanks for sharing it with us.
Phil
Re: Engraved Spyderco Byrd
Posted: Fri Apr 08, 2011 10:30 pm
by jmh58
Very, very nice.. Nice work and pic too!! John
Re: Engraved Spyderco Byrd
Posted: Sun Apr 10, 2011 3:31 am
by cavemans workshop
Thanks guys, I appreciate the comments. I don't spend as much time on knives anymore as I once did, seem to be making lots of buckles and hardware. I do really enjoy engraving knives however.
Re: Engraved Spyderco Byrd
Posted: Sun Apr 10, 2011 9:34 pm
by CharlieR
How hard was the stainless to engrave?? I hear some of those are really a pain!
Re: Engraved Spyderco Byrd
Posted: Fri May 20, 2011 3:02 pm
by orvet
I like the design.
Wish I knew how to do that and had the equipment for it.
Nice work!