Page 1 of 1
Did this have a
Posted: Sun Jul 19, 2015 2:47 pm
by steve99f
model number? Its a nice little senator that I've had for a little while. One of the tang stamp charts says 1917 to 1946. Any info would be great.
I happened to be going to Albany, NY last week and went thru Ellenville on 209N. The factory looks like a deserted property. Maybe a few businesses in there. Timing was off. Got to Canal Street just in time to see them leaving.
Re: Did this have a
Posted: Sun Jul 19, 2015 3:48 pm
by SteelMyHeart85420
Got no info to offer, but, man, that's pretty.
Re: Did this have a
Posted: Sun Jul 19, 2015 5:24 pm
by msteele6
Maybe a 2424?. If so, it's listed as being 3 1/8" long.
Re: Did this have a
Posted: Sun Jul 19, 2015 5:44 pm
by steve99f
Thanks!
It measures at 3 inches on the nose. I would love to find more of this vintage.
Re: Did this have a
Posted: Mon Jul 20, 2015 1:06 am
by tongueriver
steve99f wrote:model number? Its a nice little senator that I've had for a little while. One of the tang stamp charts says 1917 to 1946. Any info would be great.
Here is a cut from a repro of the old catalog which describes your knife. The company did not normally put pattern numbers on their knives until it was sold in late 1946. The new company was then stamped Schrade Walden, NY. A little later they started adding USA to the stamp.
Re: Did this have a
Posted: Mon Jul 20, 2015 1:16 am
by steve99f
Thank you for the cut. That is it.