Page 1 of 1

Bone handles

Posted: Sat May 11, 2019 2:57 pm
by doglegg
https://www.ebay.com/itm/Vintage-Camill ... 1438.l2649
Do the handles look right on this knife? Says bone and should be but sure looks funny to me around where the pins were spun. ::shrug::

Re: Bone handles

Posted: Sat May 11, 2019 3:09 pm
by Doc B
I'm no expert...but it looks like Delrin...like it's sort of "melted" via the spinning of the pins. If it is Delrin...that would put it after 1960. We will see what the experts say.

Re: Bone handles

Posted: Sat May 11, 2019 3:14 pm
by kootenay joe
Delrin.
kj

Re: Bone handles

Posted: Sat May 11, 2019 3:22 pm
by royal0014
Delrin .... still a decent knife.

Re: Bone handles

Posted: Sat May 11, 2019 3:45 pm
by kennedy knives
Delrin ::tu:: ::tu:: ::tu::

Re: Bone handles

Posted: Sat May 11, 2019 4:19 pm
by KnifeSlinger#81
Yes, delrin. I have seen bone with the same kind of marks from spinning the pins though.

Re: Bone handles

Posted: Sat May 11, 2019 9:34 pm
by Shearer
The knife is listed 1946-1956.
I agree its Delrin.
Delrin was not used till 1959-60


Grant

Re: Bone handles

Posted: Sun May 12, 2019 12:18 am
by doglegg
I thought the no line stamp was 1946-1947 but I see it on this one and on another one on ebay. I don't understand why tang stamp would be used in the 60's. ::shrug::

Re: Bone handles

Posted: Sun May 12, 2019 2:54 am
by Shearer
doglegg wrote:I thought the no line stamp was 1946-1947 but I see it on this one and on another one on ebay. I don't understand why tang stamp would be used in the 60's. ::shrug::
Camillus was a bit like Schrade .They did not waste anything.
If there was some old blades lying around they used them.
They tang stamp chart is only a guide to around about a timeline.
So when I look at a knife I also look at handle material.

Hope this helps.

Grant

Re: Bone handles

Posted: Sun May 12, 2019 2:57 am
by doglegg
Thanks Grant. ::handshake::

Re: Bone handles

Posted: Sun May 12, 2019 3:18 am
by Mumbleypeg
The OP knife, for posterity.

Ken

Re: Bone handles

Posted: Sun May 12, 2019 1:22 pm
by doglegg
Thanks Ken. ::handshake::