Page 1 of 1
Need Robeson name shield
Posted: Wed Jun 26, 2019 6:49 pm
by Tarheelnative
I'm reaching out to see if anyone has or knows where I can get a Robeson name shield. The knife is a Robeson strawberry bone sleeve board. I love this old knife and I'm grieving over losing the name shield. Any help would be appreciated.
Scott
Re: Need Robeson name shield
Posted: Thu Jun 27, 2019 1:52 am
by FRJ
Welcome here, Tarheelnative.
That's too bad about loosing that shield. I hope you can get a replacement for it. Sorry, I can't help.
Is there a number on the back side of the main blade?
Re: Need Robeson name shield
Posted: Thu Jun 27, 2019 6:25 am
by RobesonsRme.com
Looks like a 622253 Senator.
Best bet is to buy a junker off Ebay that has a shield in place.
A good many Robeson knives from this era had the shields glued in place. They tend to fall out.
Charlie
Re: Need Robeson name shield
Posted: Thu Jun 27, 2019 7:38 am
by cudgee
Tarheelnative wrote:I'm reaching out to see if anyone has or knows where I can get a Robeson name shield. The knife is a Robeson strawberry bone sleeve board. I love this old knife and I'm grieving over losing the name shield. Any help would be appreciated.
Scott
I feel your pain, especially with a old knife with a personal attachment. I have had to glue back shields i a few of my case knives, but at least i did not lose the shield. Good luck in getting a replacement.
Re: Need Robeson name shield
Posted: Thu Jun 27, 2019 1:14 pm
by RobesonsRme.com
Re: Need Robeson name shield
Posted: Sat Jun 29, 2019 10:21 pm
by Byrd
If this will work I'll send you the knife. I got it at a yard sale for $1. The number on the blade is 62215 something. I can't make out the last number. If you think it'll fit PM me your address and I'll send it to you.
Re: Need Robeson name shield
Posted: Sat Jun 29, 2019 10:53 pm
by cudgee
Byrd wrote:If this will work I'll send you the knife. I got it at a yard sale for $1. The number on the blade is 62215 something. I can't make out the last number. If you think it'll fit PM me your address and I'll send it to you.
The good Karma bus will stop and pick you up. That is a very kind and good offer. You will be rewarded in kind at some point.Well done.
Re: Need Robeson name shield
Posted: Sat Jun 29, 2019 10:54 pm
by RobesonsRme.com
I think there were two different sized shields. Make sure its going to fit the bed.
Charlie
Re: Need Robeson name shield
Posted: Sun Jun 30, 2019 2:26 pm
by Byrd
The measurements on this shield are .792 long by .175 wide. Let me know if that's the size you need.