All About Pocket Knives

I have a Swan Works Cutlery knife made in Solingen Germany. It has two blades and I believe bone handles. One blade is 2 1/4" and the other is 1 1/2". The smaller blade has broken off about 1/8" from the tang. I am looking for a replacement blade, which I'm sure is like looking for a needle in a haystack. Attached are a couple of photos of the knife.

I’ll just bet you are going to have to consider having a pen blade welded on to save that tang stamp. Or..... delete the pen blade altogether. That would make a nice slim knife. Good luck with your quest.

Suredan, I thought about the possibility of having a blade welded on the tang to save the stamping, but I don't know who does that type of work. I probably should post in the repair/restore forum. I would really like to keep the knife as original as possible. Thanks for your input.

Jerry Johnson

Check your PM's