Page 1 of 1
Benchmade Bedlam Auto Axis
Posted: Wed Apr 14, 2021 2:20 pm
Does anyone on this forum know what thread size the large inner screws on a benchmade Bedlam Auto ???
Thanks
CC
Re: Benchmade Bedlam Auto Axis
Posted: Wed Apr 14, 2021 5:12 pm
by Papa Bones
I can't answer your question, but you could contact Benchmade and find out if they have replacements, or if they can give you the information.
1-833-557-2526
Benchmade
300 BeaverCreek Road
Oregon City, OR 97045
email =
[email protected]
Re: Benchmade Bedlam Auto Axis
Posted: Wed Apr 14, 2021 5:48 pm
by Mumbleypeg
We think alike Smitty.
viewtopic.php?f=96&t=70736
Apparently it didn’t work (or he didn’t like that answer.)
Ken
Re: Benchmade Bedlam Auto Axis
Posted: Wed Apr 14, 2021 8:18 pm
I called benchmade yesterday and the lady that answered said they couldn't tell me the screw and thread size because it would promote after market parts !!!!! So I ordered a screw identifier !!!!
Thanks
CC
Re: Benchmade Bedlam Auto Axis
Posted: Wed Apr 14, 2021 10:11 pm
by knife7knut
Any good hardware supply store will have a large selection of nuts and bolts in both metric and USA threads.I would take a sample or even the knife that is missing the screw to one and start going through their selections.The most common size I have seen used is a 2-56 thread.
Re: Benchmade Bedlam Auto Axis
Posted: Wed Apr 14, 2021 10:51 pm
by Mumbleypeg
[email protected] wrote: ↑Wed Apr 14, 2021 8:18 pm
I called benchmade yesterday and the lady that answered said they couldn't tell me the screw and thread size because it would promote after market parts !!!!! So I ordered a screw identifier !!!!
Thanks
CC
That’s discouraging to say the least. I assume you’re trying to replace a lost/missing screw? I would have expected them to offer to send you a new one, given what their knives cost. Or at least offer to sell you one if they don’t consider it covered by warranty.
Most good hardware stores will have a selection of screws and someone to help. If there is another screw of the same size in the knife, as Ray suggested, remove it, place it in a baggie and take it with you to see if they can match it. Some Loctite cement might be a good investment too.
Ken
Re: Benchmade Bedlam Auto Axis
Posted: Wed Apr 14, 2021 11:04 pm
by Papa Bones
[email protected] wrote: ↑Wed Apr 14, 2021 8:18 pm
I called benchmade yesterday and the lady that answered said they couldn't tell me the screw and thread size because it would promote after market parts !!!!! So I ordered a screw identifier !!!!
Thanks
CC
Wow.....heck of a customer relations right there.
Kind of a negative to me for them.