Page 1 of 1
Boy's knife based on Sheffield souvenir knife pattern
Posted: Wed Oct 25, 2023 3:11 am
by ashwinearl
I rebuilt this knife from a one I'd abandoned few months ago. Single bolster boy's knife with some threading. Iron wood, 8670 carbon steel. SS liners, shield.
[youtube]
https://youtu.be/M9uY0DaRgwg[/youtube]
Re: Boy's knife based on Sheffield souvenir knife pattern
Posted: Wed Oct 25, 2023 9:46 am
by eveled
That came out nice.
Re: Boy's knife based on Sheffield souvenir knife pattern
Posted: Thu Oct 26, 2023 12:04 pm
by Meridian_Mike
Very nice!!
Re: Boy's knife based on Sheffield souvenir knife pattern
Posted: Thu Oct 26, 2023 1:30 pm
by doglegg
Agree.
Re: Boy's knife based on Sheffield souvenir knife pattern
Posted: Thu Oct 26, 2023 10:55 pm
by treefarmer
That's a mighty handsome knife!
The video showing the blade being pushed open from the half stop position with a thumb against the edge is kinda spooky.
Treefarmer
Re: Boy's knife based on Sheffield souvenir knife pattern
Posted: Fri Oct 27, 2023 1:36 am
by ashwinearl
treefarmer wrote: ↑Thu Oct 26, 2023 10:55 pm
That's a mighty handsome knife!
The video showing the blade being pushed open from the half stop position with a thumb against the edge is kinda spooky.
Treefarmer
The original had been completed and fully sharpened. When I decided to take it apart and redo some parts I tried to dull the knife up with a file. I didn't do the best job. In the video you can seem me check it a little before pressuring it. On a knife from scratch it usually isn't a problem IF I do my grinding correct and there is still some thickness at the edge.
There is keen edge on there now so I won't be doing that move again on this knife.