Page 1 of 1
Ulster Electrician Knife
Posted: Thu Apr 02, 2026 1:14 am
by Panzer2085
Here is one I just did in rose wood. It took some time to finish because I had to re due the pivot pin 3 times. The first 2 times while trying to blend it with the bolster I ended up sanding just a little bit too much off and they came loose.
The 3rd was a little better even though I couldn’t get the pin to blend with the bolster you can’t feel it and it functions perfectly. I decided to add a shield just to dress it up a little bit more. Is it a museum piece? No but it’s a great user for someone to enjoy.
Re: Ulster Electrician Knife
Posted: Thu Apr 02, 2026 7:04 am
by orvet
Looks good, nice work!
Re: Ulster Electrician Knife
Posted: Thu Apr 02, 2026 8:56 am
by royal0014
Knot too shabby .. ... ..
Re: Ulster Electrician Knife
Posted: Fri Apr 03, 2026 10:52 pm
by glennbad
Looks like it is a solid build, nice work!
Re: Ulster Electrician Knife
Posted: Fri Apr 03, 2026 11:04 pm
by L8Tagain
Wonderful! Great job!
Re: Ulster Electrician Knife
Posted: Sat Apr 04, 2026 1:03 am
by Reverand
That is a great look! I rarely think of a light colored wood with Electrician's knives, and I see that I need to rethink that!
Re: Ulster Electrician Knife
Posted: Sat Apr 04, 2026 4:26 am
by Scale Military
Thats quite nice!
Re: Ulster Electrician Knife
Posted: Tue Apr 07, 2026 11:36 pm
by Panzer2085
Thank you everyone for the positive comments. The pictures don’t do it justice it definitely looks better in person. I’ve redone a few Electricians knives for a couple of reasons. One they’re not bad to work on and two you can usually pick them up for cheap. They’re probably one of the cheapest American made knives you can pick up regardless of the manufacturer.
Re: Ulster Electrician Knife
Posted: Sat Apr 11, 2026 11:08 pm
by American Blade 92
Panzer2085 wrote: ↑Thu Apr 02, 2026 1:14 am
Here is one I just did in rose wood. It took some time to finish because I had to re due the pivot pin 3 times. The first 2 times while trying to blend it with the bolster I ended up sanding just a little bit too much off and they came loose.
The 3rd was a little better even though I couldn’t get the pin to blend with the bolster you can’t feel it and it functions perfectly. I decided to add a shield just to dress it up a little bit more. Is it a museum piece? No but it’s a great user for someone to enjoy.
Nice work! Looks great!