All About Pocket Knives

Curious if anyone has added jigging to a knife handle.
Did a small bit of research and the pne bur a gur recommended is a flat disk byr from mcmaster carr.
For jigging what other burs would be reccomended?
Would want to try barn board jigging, winterbottom and a kind of checking, like on gunstocks

Scale Military wrote: ↑Wed Jul 22, 2026 5:37 am Curious…..

Maybe here:
https://www.allaboutpocketknives.com/kn ... m.php?f=48

I used a 1/8" carbide ball bur in a Dremel tool.

OLDE CUTLER wrote: ↑Wed Jul 22, 2026 12:31 pm I used a 1/8" carbide ball bur in a Dremel tool.

I’ve used a ball burr also, it works well but it sometimes will grab and want to change direction depending on the material.

OLDE CUTLER wrote: ↑Wed Jul 22, 2026 12:31 pm I used a 1/8" carbide ball bur in a Dremel tool.

Same. I also have small diamond burrs in different sizes. They are very inexpensive.

Thanks for all the replies!
Im going to be picking up a dremel then ill take a look around to see what I can find.