Engraved Spyderco Byrd

cavemans workshop · Post by **cavemans workshop** » Fri Apr 08, 2011 3:41 am

Here is a knife I just finished engraving. I usually overlay these with silver, making for an easier metal to engrave. This one I didn't do that, I just engraved the stainless steel handle in a Western Bright cut design. Thanks for looking, all comments welcome.

zed6309 · Post by **zed6309** » Fri Apr 08, 2011 5:56 am

That looks amazing, im sure i have seen some of your work before while googling,

johnnierotten · Post by **johnnierotten** » Fri Apr 08, 2011 8:14 pm

Great job!!

philco · Post by **philco** » Fri Apr 08, 2011 9:51 pm

That is impressive work. Thanks for sharing it with us.

Phil

jmh58 · Post by **jmh58** » Fri Apr 08, 2011 10:30 pm

Very, very nice.. Nice work and pic too!! John

cavemans workshop · Post by **cavemans workshop** » Sun Apr 10, 2011 3:31 am

Thanks guys, I appreciate the comments. I don't spend as much time on knives anymore as I once did, seem to be making lots of buckles and hardware. I do really enjoy engraving knives however.

CharlieR · Post by **CharlieR** » Sun Apr 10, 2011 9:34 pm

How hard was the stainless to engrave?? I hear some of those are really a pain!

orvet · Post by **orvet** » Fri May 20, 2011 3:02 pm

I like the design.
Wish I knew how to do that and had the equipment for it.
Nice work!

All About Pocket Knives

Engraved Spyderco Byrd

Engraved Spyderco Byrd

Re: Engraved Spyderco Byrd

Re: Engraved Spyderco Byrd

Re: Engraved Spyderco Byrd

Re: Engraved Spyderco Byrd

Re: Engraved Spyderco Byrd

Re: Engraved Spyderco Byrd

Re: Engraved Spyderco Byrd