Project Sheffield Sailor Knife Parts and Progress , I Know You Guys Like Step By Step , , Need to make a bail , Since I Have Been Up- To my ( Lol) With Life Happens , I Find This Project To Be Of The Utmost Importance ,, ( Lol )K.C. Don't Seem To Be Any Order To My Madness so you might have to piece things together ( Lol)more photo's to follow .Re-Rigged
-
KleenCut61
- Posts: 810
- Joined: Thu Mar 23, 2017 2:17 am
- Location: Ulster Co, N.Y.
- Contact:
Re-Rigged
Project Sheffield Sailor Knife Parts and Progress , I Know You Guys Like Step By Step , , Need to make a bail , Since I Have Been Up- To my ( Lol) With Life Happens , I Find This Project To Be Of The Utmost Importance ,, ( Lol )K.C. Don't Seem To Be Any Order To My Madness so you might have to piece things together ( Lol)more photo's to follow .- Attachments
-
-
-
-
-
-
-
-
-
-
-
KleenCut61
- Posts: 810
- Joined: Thu Mar 23, 2017 2:17 am
- Location: Ulster Co, N.Y.
- Contact:
Re: Re-Rigged
More Progress Photo's Which I edited . sorry K.C.
- Attachments
-
- Original
-
- Original
-
- Blued Steel center Liner Backsprings And Blades
-
- Coin Edge Nickel Silver Bolsters
-
-
-
Doc B
- Posts: 3700
- Joined: Fri Aug 10, 2018 10:57 pm
- Location: San Antonio
Re: Re-Rigged
I like the way your going! 
Heretical Refurb / Mods of cheap old folders, since late 2018
-
Meridian_Mike
- Posts: 5041
- Joined: Mon Apr 21, 2014 8:36 pm
- Location: Mississippi
Re: Re-Rigged
Very nice! I like all the pics you have posted that show your progress!
Your fit and finish sure looks nice!
Your fit and finish sure looks nice!
"Life is tough.... but it's tougher if you're stupid."....John Wayne
-
glennbad
- Gold Tier
- Posts: 8174
- Joined: Mon May 15, 2006 11:13 am
- Location: NH
Re: Re-Rigged
Looking good! I've done a few of those. The ones I did had nail breaking springs, so I never used anything neat like bone, I was too afraid it would crack under the strain. I used micarta on those ones. I suppose stag would be strong enough. Hmmm 
-
KleenCut61
- Posts: 810
- Joined: Thu Mar 23, 2017 2:17 am
- Location: Ulster Co, N.Y.
- Contact:
Re: Re-Rigged
Meridian_Mike wrote: ↑Fri Jun 12, 2020 12:27 pm Very nice! I like all the pics you have posted that show your progress!
Your fit and finish sure looks nice!
Thanks fella's . Going to Make a Flat long loop bail .. I think there flashy
Back spring on theses Type Knives are very strong . Nothing I would be comfortable using . So The project Begins ( Lol) Its quite possible to tweak the snap by varying Pin Hole Size and placement or so I found out . But the Liners must be Original before the modification with the pin size .. Thanks for youR Comments Will Have it completed Soon , I will take some 360 Views Should You like some ideas .. Ty K.C