blade etchings

[chetr1200c]

is there a way to take surface etchings off a blade without making it seem obvious?

[Tom Hudson]

is there a way to take surface etchings off a blade without making it seem obvious?

Yep - just takes elbow grease - get some wet or dry - use it wet - use a sanding block - change paper often & get it wet - might be able to start with 400 then 600 then? Depends how deep the etch is & how much work you want to put into it - - after getting the steel ground down you can either leave it or buff & polish - then do the other side to match - normally it's more work than most guys want to do & to costly to pay a professional to do - but it can be done - tom

[chetr1200c]

thanks tom,, btw, i did try and email you with my request but my emails must not be getting thru....

[Tom Hudson]

thanks tom,, btw, i did try and email you with my request but my emails must not be getting thru....

[email protected] is my e-mail - tom

[muskrat man]

I can remove most blade etchings for $15 plus return postage. takes about 30 min to do it right