This time I have tried in a friction folder a bit atypical, I hope you like it
Thank you for your attention
- N690Co stainless steel blade (60 hrc), satin horizontally.
- Grips in African buffalo with texture.
- Grips milled internally embedded with a reinforced brass to make the pivot pin and the stop-over solids.
- Pivot (made by me on a lathe) with anti-rotation system.
- Stainless steel screws.
- Stop Pins hardened steel.
- Length when open 6.7 in - 17 cm
- blade length (cutting edge) 2.36 in - 6 cm
- closed length 4.73 in - 12 cm
- blade thickness 3 mm
- weight 2.47 OZ - 70 g
http://imageshack.us/a/img42/8277/p4k3.jpg
http://imageshack.us/a/img542/5047/847j.jpg
http://imageshack.us/a/img201/861/0nu0.jpg
http://imageshack.us/a/img6/7233/flsx.jpg
http://imageshack.us/a/img38/4313/t7b8.jpg
http://imageshack.us/a/img809/2840/ivst.jpg
Best wishes
